It is intended to replace the poly-bottom sweep of the expander on a. For the best shopping experience, enable JavaScript. Slides into existing door sweep slot Easy to install. Shop for sweeps for all Andersen and EMCO Fullview storm doors with interchangeable windows and insect screens. This is due to manufacturer changes in the material to provide more cost efficient replacements for doors and windows. Expander storm door sweeps are used on the bottom of the door for a tighter seal. Larson genuine storm door replacement sweeps fit Larson storm doors manufactured after 2000 and. Do not be alarmed that you only have 1 piece to your new sweep and removed 2 from the original. Then take a rubber mallet and gently tap it onto the door the rest of the way until it lines up flush on the edges. Slowly feed the sweep onto the door until you can not slide it on my hand any longer. You will want to line these up with the slots on the base of your door and begin to push the new part on. Look at your new storm door sweep, and you will see two lips or edges on the tips of it, that run down the length or the material. Once you have this out, you will notice the slotted notches on the bottom of the door that held the old sweep into place, you will be using this to mount the new one. The sweep measures 37-1/4-in long and can be cut to fit. Save on energy costs with the simple addition of a door sweep that seals the gap between the bottom of an entry door and its threshold. Take your pair of pliers and grab the outside edge of the sweep gently by the tip and slowly pull it out as well. Double expander sweep is applied to the bottom of door for a tight seal. The next section to your storm door sweep is the actual channel that hooks to the door, that the rubber connects to. At this angle, it will be easier to do the work that is needed, without having to remove the door from the hinges. Grab the base of the door sweep, and gently pull toward you, and the plastic or rubber lining will start to come free from the door, sliding outward from the doors base. Start the removal process by placing your right hand on the door near the door latch or lock, and then reaching down to the end of the door sweep with your left hand. The first thing to do is open the door to reveal its edge, here on the side on the base of the door, you should see a plastic or rubber cap at its base, this is your storm door sweep.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |